| |
- Timing Shim - .049
- Fits between Cyclinder & Crank Case
- To suit - All Surestart and earlier - 2 in Pack
- Was -
Au$3.95
Now - Au$3.16
- Rubber Wheel - Cushioned - Weight = 11g
- Height = 35mm (1 3/8")
- Takes 2.5mm (3/16") axle easily enlarged to 3mm (1/8")
- To suit - All small Model Aircraft - 1 in Pack
- Was -
Au$3.95
Now - Au$3.16
- Mixture Needle Spring - Surestart .049
- To suit - All Surestart - 3 in Pack
- Was -
Au$3.45
Now - Au$2.76
- Mixture Needle - Long .049
- To suit - All Surestart with Choke Tube fitted - 3 in Pack
- Was -
Au$3.95
Now - Au$3.16
- Starter Spring & Cam -
Normal Direction - .049
- To suit - All Surestart Engines - 1 each in Pack
- Supplied with all Classic Engines
- Was -
Au$2.95
Now - Au$2.36
(1 only - with each Engine purchased)
- Was -
Au$5.95
Now - Au$4.76
(1 only - per order without Engine)
- Mixture Needle - Short .049
- Better for Engines without a Choke Tube
- To suit - All Surestart - 2 in Pack
- Was -
Au$3.95
Now - Au$3.16
|
- Cox Icon CS6 Micro Servo - RC
- Torque 9.9oz-in (.72Kg-cm)
- Speed 0.10s - 60 degrees
- Weight 6 grams
- Voltage 4.8v - 6v
- Dimensions 20.1mm * 11.2mm * 19.3mm
- Was -
Au$11.00
Now - Au$9.00
- (This item is temporarily out of stock.)
- Glow Clip - complete - .049
- Durable plastic clip - wire 440mm
- To suit - All Surestart & earlier - 1 in Pack
- Was -
Au$16.95
Now - Au$13.56
- (This item is temporarily out of stock.)
- Flying Lines - Dacron 54 feet(16.45M)
- Kink free
- To suit - All .049 engines - 2 in Pack
- Was -
Au$4.40
Now - Au$3.52
- Thimbles Large - 4.5mm Dia.
- Brodak BH321
- To suit - medium to heavy lines - 12 in Pack
- Was -
Au$3.95
Now - Au$3.16
- Hub & Stud - 9.5mm .049 Weight = 6.8g
- To suit - Surestart & earlier - 1 each in Pack
- Was -
Au$2.95
Now - Au$2.36
Uses -
This hub can be used to help balance a model that is too heavy in the tail. Rather than add Lead add
the Hub instead.
It can also be used to press the Prop Plate further onto the crank.
- Remove the back plate and hold the crank still.
- Place the stud into the crank, fit 2 washers, fit an old prop, fit 2 more washers
and tighten the hub.
- Leave at least 0.5mm clearance (or slightly more) between the Prop Plate and the Crank Case.
|
|
