Medallion 09 - Prop Screw & Washer - Original Factory Part - #2319

New condition - Old stock - Original Cox Factory Part - in an original Cox bag. X- estate - Packet shows signs of age 1 set in pack. to fit Cox .09 Medallion Engines the pack contains 1 x...

Needle Springs - Bee - (WMA-125)

3 in pack. Will fit integral tanks (bolt on) for Classic Bee – Babe Bee – Black Widow and others.

Needle Springs - Surestart - (WMA-124)

3 in pack. Will fit Surestart engines with back plates. Will not fit engines with integral tanks. Not for use with Bee engines.

Prop Screw - .049 - (Short) - (WMA-136)

4 in pack. Correct length when not using a Spinner.

Prop Screws - .049 - (Long) - (WMA-137)

4 in pack. Correct length when a Spinner is used.

Propeller Spacer (Cox) - for 7in & 8in Props - (WMA-182)

Set of three (3) Features:Spacer for 5-40 Screw & 7" prop Spacer for 5-40 Screw & 8" prop Tough Nylon material Brand new Current Production itemApplication:All...

Radial Mount - (W-175-U)

Brand New - No Packet 1 set in pack. Includes 2 x M3 x 25 bolts and 2 x M3 Hex Nuts. This mount is designed to help you replace a Cox Bee engine with a Cox Surestart engine. The mount is designed to...

Rear Case Screws - Silver - (WMA-167)

4 in pack. Cox .049. Use these machine screws to attach a grey Surestart rear assembly to either a machined or Die Cast .049 crankcase..

Reed Retainer - Machined - (Black) - (WMA-130)

1 in pack. For use with black Surestart backplates (Rear Assemblies) and some nylon tank shells which don't use an E-clip.

Reed Retainer - Machined - (Grey) - (WMA-128)

3 in pack. Use the grey retainer with grey back plates, or integral tanks that don't require an e-clip, when fitting to a machined crankcase.

Starter Spring - Classic - Left Hand - Used

Used item Good condition  1 in pack. Starter spring. Simply wind the prop backwards against the spring and let it go. Will fit most Cox .049 engines. Left hand means it will start the...

Starter Spring - Surestart - Left Hand - Used

Used item Good condition  1 set in pack. Starter spring with nylon hex plate. Simply wind the prop backwards against the spring and let it go. Will fit either a Machined or a Die Cast .049...